- As TimeReceiver in ptp.mode hybrid: Delay_Req unicast to the GM (IP
from its Announce, MAC recorded by the RX hook from its Sync frames),
unicastFlag set.
- As TimeTransmitter: a Delay_Req with the unicastFlag gets a unicast
Delay_Resp; multicast requests get multicast replies.
- EMAC timestamps every received frame (en_ts4all): its PTP filter left
unicast Delay_Req unstamped ("no HW RX timestamp").
- A unicast Delay_Resp's logMessageInterval 0x7F is ignored (use
ptp.log_delay_req); log_us() clamps to -7..6 (the shift was undefined).
- Verified vs ptp4l --hybrid_e2e 1: board hybrid TimeReceiver 18
Delay_Req in 20 s, all answered, locked; board TimeTransmitter
(p1 100): tcpdump shows Sync/Follow_Up/Announce to 224.0.1.129,
Delay_Req 192.168.192.233 -> .244 [unicast] and Delay_Resp .244 ->
.233 [unicast] within 0.4 ms; ptp4l s2.
- Docs: TimeTransmitter/hybrid notes; step 6 ticked.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- aes67_cfg: cfg_set_number(group, key, value, apply) for firmware-side
changes, stored in NVS like a POST; apply can be skipped.
- aes67_sdp_sap: once a second, a change of the PTP GM (ts-refclk) bumps
aes67.session_ver without re-applying the aes67 group (no stream
restart); SAP then re-announces. Runs whether or not SAP is on.
- Verified with ptp4l as a normal clock (p1 128): board auto (p1 250)
steps down to SLAVE (session_ver 1->2); role master p1 100 via API ->
board MASTER at once (->3); back to auto p1 250 -> ptp4l takes over
within ~1 s, board SLAVE again (->4).
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
SAP, syslog and health/temperatures are done and verified. The VLAN
split needs a tagged VLAN with DHCP on the switch and is only needed
for the internet sources, so it moves to a phase 2 section. Step 4
notes what is still open (Riedel import, Wireshark).
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- aes67_health: status.temps = [{name, c, min_c, max_c, warn_c}]
(0.1 °C), sampled every 2 s by a health task. On-die "SoC" sensor via
driver/temperature_sensor.h, range 20..100 °C, warn at 85 °C.
health_temp_register(name, read_cb, warn_c) for board sensors.
Warning logged when crossing warn_c, cleared below warn_c - 5 °C.
- Verified: SoC 26-28 °C at idle with min/max since boot; with a
temporary 27 °C threshold the warning was logged and arrived via
syslog as <132>, status carried warn_c 27.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- aes67_sdp_sap: SAP (RFC 2974) announcer task. SAPv1 to
239.255.255.255:9875 every 30 s and within 1 s of any SDP change
(config save, GM change), with the old hash deleted first. Active while
aes67.discovery = sap, the stream is enabled, the AES67 interface has
an IP and a PTP GM is known. Deletion when that stops and at shutdown
(reboot/OTA) via a shutdown handler. TTL = aes67.ttl.
- Docs: SAP implementation notes; session_ver bump on GM change still open.
- Verified with a SAP listener: 30 s repeats with a stable hash; rename
-> delete old + announce new (o= version follows); manual -> delete;
sap -> announce; reboot and OTA -> delete at shutdown, first announce
after boot only once the GM is known.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- Web UI PTP panel checked in the browser.
- GM loss test (ptp4l stopped): SLAVE -> LISTENING after the announce
timeout, frequency held; ptp4l restarted: UNCALIBRATED -> SLAVE in 22 s.
- Docs: P4 PTP implementation notes (UDP timestamp bit, RX hook, raw
Delay_Req, servo, measured results, link asymmetry).
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Test on board (ESP32-P4 rev v1.3):
- Rejected with 400 and nothing booted differently: garbage, wrong
project, min chip rev v3.0, truncated image.
- A (USB, ota_0) -> B via /api/ota: self-test passed, confirmed.
- Manual rollback B -> A; A -> B again.
- B -> C (forced self-test failure): C boots on trial in ota_0, fails,
rolls back to B in ota_1.
- D installed over the network; a later truncated upload hides
'previous' and clears can_rollback.
Docs: network flash command, serial-reset caveat, rollback test build,
OTA details in aes67-core-base.md.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- aes67_net: esp_netif_set_hostname() before the interface starts, and
in the net apply callback (takes effect at the next lease renewal).
- Verified: the router's DNS (lan.apointless.space) resolves p4-aes67
to 192.168.192.244.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- aes67_net/lldp.c: IEEE 802.1AB LLDPDU sent as a raw frame with
esp_eth_transmit every 30 s (TTL 120 s) and immediately on a new IP
or hostname change. TLVs: chassis/port ID (MAC), port description,
system name (net.hostname), system description (project + version),
capabilities station-only, IPv4 management address.
- Docs: LLDP in the core Network section; step 2a ticked.
- Verified on an HP 2530-8G-PoE+ (show lldp info remote-device 2): all
fields shown, management address 192.168.192.244.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
- aes67_net: espressif/mdns 1.13.1 (managed component, pinned in
dependencies.lock). Advertises <net.hostname>.local and the web UI as
_http._tcp port 80. net apply callback renames live.
- First config value actually applied: net.hostname.
- Docs: mDNS in the core Network section; build order gets step 2a
(mDNS, then LLDP).
- Verified on board: p4-aes67.local resolves via raw mDNS and getent,
http://p4-aes67.local/ answers, service shows in _http._tcp browse;
live rename to p4-rename and back works (after ~1 s probing).
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
bsncubed