PTP: hardware timestamping is not a setting any more
The hw_ts config key was never read (hardware timestamps are always used); the checkbox suggested it could be turned off. Removed from the config, the page and the docs; status.ptp.hw_ts still reports it. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
@@ -18,7 +18,7 @@ Reference devices for UI and defaults: Riedel Bolero (PTP status), Riedel Direct
|
||||
- PTP preset buttons: "Riedel SIC defaults" and "AES67 media profile defaults" fill the form (Save to apply).
|
||||
|
||||
## Config schema (core groups)
|
||||
- ptp: {mode: multicast|hybrid, role: slave|auto|master, domain, priority1, priority2, log_sync, log_announce, announce_timeout, log_delay_req, dscp, hw_ts}
|
||||
- ptp: {mode: multicast|hybrid, role: slave|auto|master, domain, priority1, priority2, log_sync, log_announce, announce_timeout, log_delay_req, dscp} (hardware timestamps always; not configurable)
|
||||
- aes67: {name, enabled, discovery: manual|sap, mcast, port, ttl, dscp, channels, mono_sum, encoding: L16|L24, rate: 48000 only (all sources are 48 kHz), ptime, pt, ssrc, clk_offset, session_id, session_ver}
|
||||
- net: {hostname, vlan, web_on: both|inet|aes67, dhcp, ip, mask, gw, dns} (AES67 / untagged interface)
|
||||
- inet: {vlan_id, pcp, dhcp, ip, mask, gw, dns} (internet / tagged, only if net.vlan)
|
||||
|
||||
+1
-2
@@ -118,7 +118,7 @@ The secret is write-only: after saving, the field shows empty. Leave it empty to
|
||||
|
||||
## PTP
|
||||
|
||||
The board locks its media clock to the PTP grandmaster on the network (IEEE 1588-2008, UDP/IPv4, E2E). *PTP status* shows the lock state and the grandmaster.
|
||||
The board locks its media clock to the PTP grandmaster on the network (IEEE 1588-2008, UDP/IPv4, E2E, always with hardware timestamps). *PTP status* shows the lock state and the grandmaster.
|
||||
|
||||
| Setting | Default | Notes |
|
||||
|---|---|---|
|
||||
@@ -127,7 +127,6 @@ The board locks its media clock to the PTP grandmaster on the network (IEEE 1588
|
||||
| Domain | 0 | Must match your grandmaster. |
|
||||
| Priority 1 / 2 | 250 / 250 | Lower wins the grandmaster election. |
|
||||
| Intervals, timeout, DSCP (46) | | Presets below set them. |
|
||||
| HW timestamping | on | Leave on (much more accurate). |
|
||||
|
||||
**Presets:**
|
||||
- **Riedel SIC defaults:** TimeReceiver only, priorities 128/126, Riedel's intervals. Use this when a Riedel system provides the clock.
|
||||
|
||||
Reference in New Issue
Block a user